Filter
Top Products
Chapter 3: Main Menu and SubMenus
To access the RCM8 Main Menu VIA MODEM:
1. Make sure RCM8 and attached modem are turned on and
properly configured.
2. On the remote PC, set up terminal emulation session for
dial-out access – Connect Using an attached modem, rather
than direct connect to a com port.
3. Once a connection has been established with the RCM8,
press Space Bar to initiate the log-in process.
4. Type the RCM8 password, then press Enter to gain access to
the RCM8. The factory-default password for modem access
is also “RCM8”.
5. From here, continue to Step 3 of the local login process.
Configuration
The Configuration option from the Main Menu lets you view the
current RCM8 settings.
1. Press 1 to display the Configuration menu:
RCM8 V4.0 CONFIGURATION - MON 07-05-99 18:03:20
SITE ID = WEST WING COMPUTER ROOM PAGER ID - 5551149
IN DELAY NO DIAL ALT DIAL MESSAGE
MM:SS NC A CODE B
-------------------------------------------
01 00:00 NO 1 0 0 WATER UNDER FLOOR
02 00:00 NO 1 0 0 HIGH TEMP
03 05:00 NC 2 & 1 DOOR HELD OPEN
04 00:00 NO 0 0 0 CLOGGED FILTER
05 00:00 NO 0 0 0 HIGH HUMIDITY
06 00:00 NO 0 0 0 CONTACT #6
07 00:00 NO 0 0 0 CONTACT #7
08 00:00 NO 0 0 0 CONTACT #8
RCM8 Phone Number =
Phone Number 1 = 9,5551212,,,,,911##
Phone Number 2 = A9,18007596366
Dial Prefix = ATE1X4DT
Redial Tries = 2
Redial Interval = 30
Modem = CONNECTED
Modem Baud Rate = 1200
EIA-485 Online Units =
This is a view-only screen. Use the remaining Main Menu
options to make changes or reset the values shown in this
screen.
2. Press Esc to return to the Main Menu.
Liebert RCM8 • 17