Land Rover Range Rover Automobile User Manual


 
5
4
Comfort and safety
The steering column adjustment stalk is located
on the left hand side of the steering wheel.
The steering wheel position can be adjusted in
four directions, corresponding with the
movement of the adjustment stalk.
With the vehicle stationary, move the stalk up
and down to adjust the height, and forward or
rearward to move the steering wheel further
away or closer.
Driver’s seat adjustment Steering column adjustment
Driving position memory
Door mirrors and electric windows
1. Lumbar support switch.
2. Seat fore/aft, cushion height
and cushion angle switch.
3. Seat back switch.
4. Head restraint switch.
5. Driving position memory
controls.
Once you have adjusted the driver's seat,
steering column and exterior mirrors for your
ideal driving position, the vehicle can memorise
these settings for future use.
1. Press the M button to activate the memory
function. The button will illuminate to indicate
the memory function is active.
2. Press button 1, 2 or 3 to store the current
driving position to the chosen number.
With the driver's door open, you can recall a
stored seat position with a press of the
appropriate button; 1, 2 or 3. The seat, steering
wheel and mirrors will move to their preset
positions.
If the driver's door is closed, turn the starter
switch to position
II
before pressing the seat
memory button.
2
4
1
3
Door mirrors
To adjust the door mirrors, move the mirror
selector switch 3 left or right to select the
appropriate mirror. Use the four-way switch 2 to
adjust the position.
Powerfold mirrors (when fitted)
The door mirrors are designed to fold back to
enable the vehicle to negotiate narrow
openings.
Press the mirror fold button 1 to fold the mirrors
back.
Press this button again to return the mirrors to
the normal position.
5321 4
Resonance with lowered windows
If a resonance/booming sound occurs when
a rear window is open, lowering an adjacent
front window about 25 mm (1 inch) will
eliminate the condition. Press the window
switch lightly to lower the window and
release when the window reaches the
required position.
If button 1, 2 or 3 is not pressed within seven
seconds of the M button being pressed, the
memory function will cancel.
Electric windows
The windows are fitted with a facility that allows
them to be fully opened or closed with a single
operation.
To open a window, fully press the respective
window switch.
To close a window, pull the respective window
switch fully upwards.
The rear window controls can be inhibited by
pressing button 4.
Clock setting
To set the time, press the system
settings button.
From the system settings screen,
touch the Clock icon to access
the Set Clock screen.
INFO
Format
Set Clock
Set Date
Set Clock
OK
17 32
12hr
mm/dd
24hr
dd/mm
24hr
dd/mm
12hr
mm/dd