Filter
Top Products
0
0
BB
0
0
AA
MAINTENANCE WORK ON CHASSIS AND ENGINE 67
9.16Adjusting the handlebar anglex
100279-10
– Loosen screw.
– Move the handlebar to the desired position and slightly tichten the screws.
– Move the handlebar carefully in both directions as far as it will go.
» If the handlebar instruments touch the fuel tank:
– Correct the handlebar angle.
Info
The distance between the handlebar support and the handlebar clamp
must be the same at the front and rear.
– Fully tighten screw.
Specification
Screw, handlebar clamp M8 20Nm
(14.8lbfft)
Loctite
®
243™
9.17Handlebar position
400271-11
On the upper triple clamp, there are 2 holes at a distance to each other.
Distance between holes 15mm (0.59in)
The holes on the handlebar support are placed at a distance from the center.
Distance between holes 3.5mm (0.138in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.