Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 104
100277-10
– Disconnect the negative (minus) cable of the battery.
– Pull off connector in an upward direction.
– Remove screws.
– Pull retaining bracket of the battery forward and remove it.
– Take off the positive terminal cover.
– Disconnect the positive (plus) cable of the battery.
– Press the wiring harness to one side and pull the battery out of the battery rack.
Info
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components can safety equipment can be damaged. The
vehicle is then no longer safe to ride.
9.51Installing the batteryx
100277-11
– Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
– Attach the positive cable and mount positive terminal cover.
– Position retaining bracket.
– Mount and tighten screws.
Specification
Remaining screws, chassis M6 10Nm (7.4lbfft)
– Plug in connector.
– Attach the minus cable.
– Mount the seat. ( P. 103)