Filter
Top Products
9.9
Section 9
Disassembly
9
Figure 9-31. Removing Center Mounting Nut.
2. Cut the metal tie strap from around the lower
hose/tube assembly, secured to the blower
housing. See Figure 9-32.
Remove Radiators and Cooling System
1. Remove the hex. nut from the center mounting
stud, located between the two radiators and
through the main support bracket. See Figure 9-31.
Figure 9-32. Cutting Tie Strap off.
Figure 9-33. Rear Bracket/Clamp.
Figure 9-34. Unseating By-pass Hose.
3. Remove the two screws attaching the rear
support bracket and half clamp to the crankcase,
on the oil filter side. See Figure 9-33.
Figure 9-35. Moving Hose Clamp with Special Pliers.
5. Unseat the clamps and separate the hose
connections at the outlet of the thermostat
housing and the inlet of the water pump. See
Figures 9-35, 9-36. Remove the tubular spacer
from the underside of center mount, or the
mounting stud in intake manifold. See step 1.
4. Pull the by-pass hose out of the retaining clip
beneath the main support bracket. See Figure 9-34.