Filter
Top Products
5.12
Section 5
Fuel System and Governor
Throttle Control Cable
Choke Control Cable
Kill Switch
Adjusting Screw
Dual Control High Idle
Lever Stop Screw
"Do Not Remove"
High Idle
Adjusting Screw
High Idle
Control Lever
Choke Control
Cable
Throttle Control
Cable
Z Bend
Choke Linkage
Throttle
Control
Lever #2
Kill
Switch
Choke Control
Lever #1
Left Side Pull
Right Side Pull
High Idle RPM Speed Adjustment (See Figure 5-8.)
1. With the engine running, move the throttle control
to fast. Use a tachometer to check the RPM
speed.
2. Loosen the lock nut on the high idle adjusting
screw. Turn screw outward to decrease, or inward
to increase RPM speed. Check RPM with a
tachometer.
3. When the desired RPM speed is obtained,
retighten the lock nut.
NOTE: Upon establishing the high idle RPM speed,
check for a gap between the high idle control
and the choke control. The gap may be
greater, but no less than .5 mm (.02 in).
Figure 5-8. Governor Control Connections.