Filter
Top Products
English 55
Tone Setup (DDX6 models)
You can set a Tone curve.
Display the Equalizer screen1
Touch [
] > [ ] > [Equalizer]. (page 53)
Display the Tone Control screen2
Set the Tone3
[Bass] Bass adjustment items are displayed.
[Middle] Middle adjustment items are
displayed.
[Treble] Treble adjustment items are displayed.
[Flat] Tone level becomes 0 (flat).
[FREQ] Sets the Center frequency.
[Level] Sets the level.
[Q Factor] Sets the Q factor. (Only [Bass] and
[Middle] can be set)
[Bass DC EXT] Bass DC Extend settings. (Only
[Bass] can be set)
If turned "ON", it extends the bass center
frequency to the low register by approximately
20%.
[SW Level] Adjusts the subwoofer volume.
Zone Control
You can set the front and rear audio source.
Display the Zone Control screen1
Touch [
] > [ ] > [Zone Control]. (page 53)
Set the Zone Control2
[Single Zone] Turns off the dual zone.
[Front Source] Sets the front audio source.
[Rear Source] Sets the rear audio source.
⁄
When the rear speaker sound is switched, the audio •
source that is output at the AV OUTPUT terminal is
also switched to the same source.
[Rear VOL.] Adjusts the volume of the rear
channel.
⁄
There are following limitations when zone function is set •
to "ON".
- There is no output from the subwoofer.
- <Equalizer Control> (page 54), <Space Enhancer> (page
56), <Position> (page 56), <DSP Bypass Control> (page
71), <Speaker Setup> (page 72), and <Car Type (DTA)
Setup> (page 73) are not available.