Kenwood DDX6034M GPS Receiver User Manual


 
54 DNX7340BT/DNX7340BTM/DDX7034BT/DDX7034BTM/DDX6034/DDX6034M
Audio Control
[Bass Boost] Sets the amount of bass boost.
(DNX/ DDX7 models only)
"OFF"/ "Step1"/ "Step2"
[Stream Information] Displays the present
source information.
The stream (Dolby Digital, dts, Linear PCM,
MPEG, MP3, WMA or AAC) is displayed.
Equalizer Control
You can set up the equalizer.
Display the Equalizer screen1
Touch [
] > [ ] > [Equalizer]. (page 53)
Set each item2
DNX/ DDX7 models
DDX6 models
[SystemQ] Selects an equalizer curve type.
You can select any of the following equalizer
curves.
"Natural"/ "Rock"/ "Pops"/ "Easy"/ "Top40"/
"Jazz"/ "Game"*/ "iPod"*/ "User"
* DNX/ DDX7 models only.
"User" can be selected after graphic equalizer
adjustment is carried out. See <Graphic Equalizer
Setup> (page 54).
"User" can be selected after tone adjustment is
carried out. See <Tone Setup> (page 55).
When "iPod" is selected, the [EQ] button is
deactivated. "iPod" uses its equalizer function.
[SystemQ-Ex] Selects items to be adjusted for
tone curve setup. (DDX6 models only)
If turned "OFF", only Level can be setup for
tone curves.
[EQ] Displays the Graphic Equalizer setup
screen. (page 54) (DNX/ DDX7 models only)
[Tone] Displays the Tone curve setup screen.
(page 55) (DDX6 models only)
Graphic Equalizer Setup (DNX/ DDX7
models)
You can Manually set the equalizer curve.
Display the Equalizer screen1
Touch [ ] > [ ] > [Equalizer]. (page 53)
Display the Graphic Equalizer screen2
When "iPod" is selected in <Equalizer Control>, the
[EQ] button is deactivated. "iPod" uses its equalizer
function.
Set the Graphic Equalizer3
1
1
1
1 Gain level can be adjusted by touching the
each frequency bar.
[2], [3] Sets a frequency.
[5], [] Sets a gain level.
[EQ Init] Returns to the previous level which
the gain level is adjusted.
[Flat] Tone curve becomes flat.
[Bass EXT] Bass Extend settings.
If turned "ON", it extends the 62.5 Hz to the
low register by approximately 20%.
[SW Level] Adjusts the subwoofer volume.