Filter
Top Products
Installation Instructions
OUO6050,0000A54 –19–25MAY07–1/3
Attach AutoTrac Universal Harness to
GreenStar Harness
PC8718 –UN–19OCT05
Routing and Installation View
A—CAN Bus Extension
B—Implement Connector
Depending on your vehicle’s harness configuration, the
AutoTrac Universal harness will be connected to the
GreenStar harness at one of the following locations:
GreenStar Ready Vehicles
Vehicles that are GreenStar Ready (or vehicles that have
GreenStar harnesses already installed) can be connected
at one of the following locations:
• 2- and 4- pin terminator connectors found at the CAN
bus extension (A) in the side console of a GreenStar
Ready tractor.
• If equipped with an Implement Connector the AutoTrac
Universal harness can be connected at the 2- and 4-
pin connectors on the implement connector (B).
NOTE: FOR TRACTORS EQUIPPED WITH A TECU:
Implement connector can not be used as the
source of the 2-pin power on machines equipped
with TECU.
In NA, SA and AU—Order a ’2-pin to
Convenience Outlet adapter harness (PF80873)’
from Service Parts. A second adapter harness
(RE67015) can also be purchased from Service
Parts to obtain power from a power strip.
In Europe—Order a ’2-pin to COBO Outlet
adapter harness (PF80874)’ from Service Parts.
PF80873 and PF80874 plugs into the 2-pin
connector on the ATU harness.
• If the platform already has a GreenStar Harness, the
2-pin and 4-pin connectors on the ATU harness can be
connected to the terminator connectors as shown on
next page.
PC20864 (05JUL07) 9 Installation Instructions
070507
PN=11
Continued on next page