Filter
Top Products
ASSEMBLY
13
• Fit the tabs on the hood into the slots in front of the windshield.
• Lower the hood.
14
Hood
Slots
• Fit the tabs on the bottom of the grille into the slots on the front
of the vehicle.
• Press near the top of the grille to
fit into place.
Grille
15
• Turn the vehicle on its side.
• Fit a traction band around a wheel.
• Slide a slotted screwdriver under the traction band to push the
traction band onto the ridge in the center of the wheel.
Hint: If the traction band is difficult to fit around the wheel, you
may want to soak it in warm water to soften it slightly.
• Repeat this procedure to assemble a traction band to each wheel.
• Turn the vehicle upright.
Traction
Band
Wheel
Ridge
BOTTOM VIEW
• “Snap” the ends of the spark plug wires set into the holes on
the battery retainer (engine cover).
IMPORTANT! You must install your Power Wheels
®
battery in
your vehicle before assembling the battery retainer under the hood.
Please refer to "Battery Installation" on page 13 for detailed instructions.
16
Spark Plug
Wire Set
Spark Plug
Wire End
Hole
Battery Retainer
(Engine Cover)
11
N9356pr-0920