Insignia NS-NAV02R GPS Receiver User Manual


 
9
Insignia NS-NAV02R GPS
www.insigniaproducts.com
Mounting your GPS in a vehicle
When you use your GPS in a vehicle, you can use the supplied mounting
bracket and cradle.
To mount your GPS in a vehicle:
1 Slide the mount cradle onto the end of the mounting bracket to attach
it.
2 Set the bottom edge of your GPS onto the mounting cradle, then push
the tab on the top of the mounting cradle in the direction of arrow 1
until your GPS clicks into place. To remove the unit, push the tab at the
top of the mounting cradle the opposite direction of arrow 1.
3 Lift the suction cup lever, then press the suction cup to the windshield.
4 Press the suction cup lever toward the windshield to attach the
bracket to the windshield.
5 Rotate the adjuster knob to adjust the assembly to the proper
position.
Warnings
The assembly must not be mounted so that it impairs the driver’s view of the
road.
Make sure that your car’s airbags are not obstructed by your GPS.
Attention California drivers
California Vehicle Code Section 26708 prohibits suction mounts on car windshields, side,
or rear windows, as they can obstruct the driver’s clear view.
Adjuster knob
Suction cup lever