Filter
Top Products
English-45
MAINTENANCE
Checking Tire Pressures
All four tires should have a pressure of 15 psi
/ 103 kPa / 1 bar.
Checking the Parking Brake
Visually check that no damage is found on
the lever, links, or switch belonging to the
parking brake. Perform a test drive and check
that there is sufficent braking action.
To adjust the parking brake, contact the
Husqvarna service workshop.
Checking the V-belts
Deck belt
Check every 100 hours of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks
in normal operation.
To replace belt lower the deck to its lowest
position. Remove the foot plate and belt
shields.
Use a ratchet with a 9/16” socket on the
spring idler bolt to relieve the tension on the
belt. Slide the belt off of pulley and remove
the belt.
Reverse the procedure for installation. See
the decal on the top of deck for belt routing
information.
After installation is complete check the belt for
twists.
8011-564
Tire pressures
8011-511
The parking brake in the disengaged position
WARNING!
Faulty adjustment can cause
an accident.
8011-622
Slackening the belt tensioner
8011-580
Belt routing, deck belt