Filter
Top Products
Brake Fluid Reservoir
BRAKE FLUID RESERVOIR
1
2
1
2
3
1. Full Level 2. Safe Level 3. Low Level
201
Figure
14 Brake Fluid and Coolant Access (diesel vehicle
shown)
202
Figure 15 Brake Fluid Reservoir
The brake uid reservoir (1) is located under the hood (Figure 14). Raise the hood to check the brake uid level.
During the brake uid level inspection, also inspect the following:
• The presence of brake uid on the exterior surface of the master cylinder indicates a leak.
• The brake uid reservoir diaphragm (located in the cap) should not have holes or other damage.
BRAKE FLUID
Brake uid level should be within 1/4-inch (6 mm) from the top of the reservoir (Figure 15). Also, brake uid should be
clean with no residue in the bottom of the reservoir or other evidence of contamination.
CAUTION
• Use only DOT 5 (silicone) brake uid. Use of any other type brake uid is not recommended.
Page 34 HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner’s Manual