Filter
Top Products
Controls and Indicators
9
6
11
1
3
2
B
A
C
7
10
8
13
4
5
12
15
193
Figure
7 Instrument Panel – Diesel Vehicles
WARNING
• Moving parts! Keep clear of the engine compartment while the engine is running.
CAUTION
• Do not shift the Forward/Reverse handle while the accelerator pedal is pressed. Shift the handle only
when the vehicle is at a complete stop and the engine is at idle. Failure to heed this caution could
result in damage to the transmission.
NOTE: The key can be removed only when the key switch is in the OFF position.
KEY SWITCH – DIESEL VEHICLES
The key switch (7) is mounted on the instrument panel to the right of the steering column (Figure 7). It has four
positions: PREHEAT, OFF, ON, and START.
Use the PREHEAT feature if the temperature falls below –5 °C (23 °F). Do not hold the key in the PREHEAT position
longer than 20 seconds. To preheat the glow plugs in cold weather, turn the key to the PREHEAT position, and hold it
there for 10-15 seconds. Then turn the key to the START position, and hold it there until the engine starts. If the engine
does not start after 10-15 seconds, turn the key to the OFF position and repeat the procedure. Once the engine starts,
release the key and it will return to the ON position. The engine will idle in neutral. The engine will continue to idle until
the key is turned to the OFF position. See previous WARNING, CAUTION, and NOTE.
HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner’s Manual Page 13