Filter
Top Products
5
© 2005 directed electronics, inc.
disarming
To disarm the system, unlock the doors using your factory keyless trans-
mitter. The horn will sound twice, and the parking lights will flash
twice. If the horn sounds either four or five times when disarming, refer
to the Diagnostics section of this guide. This is called Tamper Alert.
disarming without a transmitter
This feature allows you to override the system without the transmitter
should it be lost, damaged or disabled. To do this, you must have the ve-
hicle's ignition key and know where the Valet
®
switch is located.
Turn the ignition to the “run”position.
Press and release the Valet
®
switch, with-
in 10 seconds. After a few seconds the
LED will stop flashing and the vehicle
should start. If it does not, you may have waited too long. Turn the ignition
off and try again.
valet
®
mode
You can prevent your system from arming, by using Valet
®
Mode. This
is very useful when washing the vehicle or having it serviced. In Valet
®
Mode, the system will not arm, even with the transmitter, but all con-
venience functions (door locks, trunk release, etc.) will work normally.
nnoottee::
The setting for the number of times the Valet® switch
must be pressed is set in the Programming Section of this
guide.
DRW-35