Filter
Top Products
SKU 45009, 92261 For technical questions, please call 1-800-444-3353 Page 4
Unpacking
When unpacking, check to make sure all parts are included. Refer to the photo
below, and the Parts List and Diagram located at the end of this manual. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual.
Regulator
Bowl (2B)
Lubricator Metal
Guard (12C)
Air Filter Metal
Guard (9A)
Air Inlet (from
Compressor)
Air Outlet
(to Air Tool)
Air Pressure
Adjusting Rod (1B)
Pressure Gauge (12B)
Quick Release Button
Quick Release Button
Mounting Bracket
(11B)
Air Filter Body (1A)
Lubricator Body (6C)
Assembly
1. Secure the Mounting Bracket (11B) to the Regulator Bowl (2B) if the unit is to
be mounted to a flat surface. See photo above.
Use the screws holding the Regulator Bowl to the Regulator Valve (6B).
Securely tighten. The Mounting Bracket holes must face to the rear of the
unit.
2. Apply pipe thread seal tape to the fitting of the Pressure Gauge (12B).
3. Carefully screw in (clockwise) the Pressure Gauge fitting into the Regulator
Valve (6B).
Do not overtighten. Stop turning the Pressure Gauge when the scale is
facing up as shown above.
manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
REV 07/06