Filter
Top Products
Page 9SKU 66305 For technical questions, please call 1-800-444-3353.
OPERATING INSTRUCTIONS
TO PREVENT
SERIOUS INJURY:
Do not adjust or tamper with
any control or component in a
way not specically explained
within this manual. Improper
adjustment can result in tool
failure or other serious
hazards.
Position the Lift in a safe and suitable 1.
area as discussed above.
Press the Load Pedal (69) to fully 2.
lower the lift.
Pull out the Ramp (1) and Pull Ramp 3.
(8) as needed to accommodate the
length of the motorcycle.
Be sure the Front Wheel Chock (17) 4.
is rotated toward the rear of the Lift.
Roll the motorcycle up the Ramp (1) 5.
and onto the Deck Plate (16).
Roll the front wheel over the Front 6.
Wheel Chock (17) and into the Wheel
Rest (21). The Front Wheel Lock will
rotate with the wheel, supporting it
from the rear.
The Wheel Chock (17) can be ad-7.
justed to t your wheel. Remove the
Nut (18) from one end of the Wheel
Lock Axle (19), and slide the Axle out
of the Deck Plate (16). The Wheel
Lock can be moved as needed and
the Wheel Lock Axle inserted in the
appropriate holes in the Deck Plate.
Reinstall the Nut and tighten. See
Figure 3.
With a helper holding the motorcycle 8.
upright, secure the motorcycle to the
Lift using the Tie Down Points (13
and 31).
Before lifting any motorcycle, it must 9.
be securely fastened to the Lift us-
ing tie-down straps (not supplied) or
other suitable method. Two Front Tie
Down Brackets (13) and two Rear Tie
Down Brackets (31) are built into the
Lift for this purpose.
Refer to the manufacturer’s motorcy-10.
cle service manual for recommended
attachment points on the vehicle.
There must not be hazardous ob-11.
jects (such as utility lines or foreign
objects) nearby that will present a
hazard while working.
Before lifting the motorcycle, pull out 12.
the Safety Bar Lock Pin (40) to allow
the Safety Bar (75) to rest on the In-
ner Scissor Arm (35).
To Lift the motorcycle, pump the 13.
Pump Pedal (56) repeatedly until
the motorcycle is lifted to the desired
height.
Wheel Chock (17)
Pull Pin (7)
Wheel Lock Axle (19)
Front Wheel Rest (21)
Figure 3