Filter
Top Products
Page 5SKU 66242 For technical questions, please call 1-800-444-3353.
The warnings, precautions, 21.
and instructions discussed in
this instruction manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Maximum
Lifting
Capacity
22 Tons (44,000 lb.)
Required Air Pressure 90-145 PSI
Air Inlet
Fitting
1/4" - 18 NPT
Minimum
Height
13" without saddle
Maximum Lift Height 17-1/2" without saddle
Ram Travel 4-1/2"
Net Weight 85 lbs
Air Hose Length 54"
Jack Handle 49"L
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
ASSEMBLY
Assemble the Handle and its 6.x 1.
series parts that come in Box B. (See
Assembly Drawing.)
Fig. 1
Adjustable Rod (6.3)
Adapters
(12.1, 12.3,
12.4)
U-Bolts
(12.6)
Nuts (12.8)
Adapter
Holder
(12.5)
Spring Washers
(12.7)
Hitch Pin (12.9)
Outside
Tube
(6.1)
2. Attach the Adapter Holder (12.5) to
the Handle Assembly with two U-bolts
(12.6), Lock Washers (12.7) and Nuts
(12.8). (See Fig. 1.)
Tighten the Nuts to secure the a.
Adapter Holder to the Handle.
Put height adjustment Adapters into 3.
the Adapter Bracket and lock each
with a Hitch Pin (12.9). (See Fig. 1.)