Filter
Top Products
Page 5SKU 47845 For technical questions, please call 1-800-444-3353.
Operation
Note: When loading or unloading the Trailer, always block both wheels on both sides of the
wheels. See FIGURE 1.
Note: Always connect, load, and unload the Trailer on a flat, level, dry surface.
1. Attach the Connect Bar (A5) to the towing vehicle. Read the towing vehicle manual for
towing and hitch connection procedures and safety warnings.
2. To tilt the Trailer as shown in FIGURE 1, hold onto the Support Bracket (A3) firmly
while removing the L Pin (B7) and the cotter R Pin (B8). Slowly tilt the bed. If using
rear stake panel (not included), remove the panel and empty or load the Trailer.
Replace the Rear Panel.
3. When finished, bring the bed back to the original position so that the hole on the
Support Bracket (A3) lines up with the hole on the Tow Bar (A4). Replace the L Pin
(B7) and the cotter R Pin (B8).
FIGURE 1
Block both sides
of each wheel.
REV 05/03