Filter
Top Products
SKU 167 For technical questions, please call 1-800-444-3353 PAGE 9
SPANNER GAUGE (35)
FRAME HEAD (11)
(THREADS)
JAW CASE
(6)
FIGURE E
D. If you are going to clean the Jaws (7), use a steel brush and mild solvent. Then,
apply a light coat of machine oil to the Jaws. If you are going to replace the
Jaws, the entire assembly (6, 7, 8, 9, & 10) must be replaced at the same time,
due to the possibility of additional parts being damaged when the Jaws were
damaged. (See Assy. Diagram.)
E. Insert the Jaws (7) back into the Jaw Case (6).
(See Assy. Diagram.)
F. When reassembling the Jaw Case (6), make sure the wedge on the Jaw Pusher’s
(8) head lines up in between the Jaws, pushing them slightly apart.
(See Assy. Diagram.)
G. Check the distance from the head of the Jaw Case (6) to the mounting threads of
the Frame Head (11) using the gauge on the Spanner (35). With the gauge at a
slight incline, the back of the gauge should rest on the beginning of the Frame
Head threads, while the front of the gauge should rest on the front edge of the
Jaw Case (6). If it does not, tighten/loosen the Jaw Case until the distance is
corrected. (See Figure E.)
5. When storing, always store the Riveter in a clean, dry, safe location out of reach of
children.
6.
WARNING! All maintenance, service, and repairs not mentioned in this manual
must only be performed by a qualified service technician.