Filter
Top Products
SKU 167 For technical questions, please call 1-800-444-3353 PAGE 7
OPERATING INSTRUCTIONS
Nosepieces:
1. The Riveter comes with
four
Nosepieces. The Nosepiece part numbers and sizes
are as follows: (1A = 3/16”), (1B = 5/32”), (1C = 1/8”), (1D = 3/32”). (See Figure D.)
2. Use the Spanner (36) when changing Nosepieces. (See Figure D.)
NOSEPIECE
(1A, 1B, 1C, 1D)
FRAME HEAD
(11)
SAFETY CAP
(23)
TRIGGER
(40)
FRAME
CAP NUT
(22)
QUICK CONNECTOR
(53)
FIGURE D
To Operate The Riveter:
1. Make sure the Safety Cap (23) is firmly secured to the Riveter by tightening the
Frame Cap Nut (22). Also, make sure the slot in the Safety Cap is turned upward to
avoid spilling used rivet pins. (See Figure D.)
2. Depending on the size of rivet’s pin (not included) used, attach the corresponding
Nosepiece size (3/16”, 5/32”, 1/8”, or 3/32”) with the Spanner (36).
(See Figure D.)
3. IMPORTANT: When drilling rivet holes in a workpiece, make sure to use the same
diameter drill bit as the outer diameter of rivet you will be using.
4. Attach an air hose to the Quick Connector (53) of the Riveter. (See Figure D.)
5. Turn on the air compressor, and set its regulator at 90 PSI.
Do not exceed 90 PSI.