Filter
Top Products
40 Edge 605/705 Owner’s Manual
USinG acceSSorieS
pedal magnet must line up
with the indication line on the
GSC 10.
3. Unscrew the
spoke magnet
from the plastic piece. Place
the spoke in the groove of
the plastic piece and tighten
slightly. The magnet can face
away from the GSC 10 if there
is not enough room between
the sensor arm and the spoke.
The magnet must be aligned
with the sensor arm indication
line.
4. Loosen the screw on the
sensor arm and move it to
within 5 mm of the spoke
magnet. You can also
tilt the GSC 10 closer to
either magnet for improved
alignment.
GSC 10 and Magnet Alignment
Spoke magnet
Sensor arm
indication line
Pedal magnet
GSC 10