Filter
Top Products
GPSMAP
®
500 Series Owner’s Manual 39
InStallInG the unIt
InstallInG the unIt
To successfully operate your unit, you must properly install the unit
and all of its related parts. Compare the contents of this package
with the packing list on the box. If any pieces are missing, contact
your Garmin dealer immediately. Before you begin the installation:
• Read and follow the instructions to install the unit.
• Gather the appropriate fasteners and tools.
• Verify that all cables can reach the unit mounting location and
the transducer.
• Wear safety goggles and a dust mask when drilling, cutting, or
sanding.
If you experience difculty installing the unit, contact Garmin
Product Support or contact a professional installer.
NOTE: References to a transducer in this section apply only to
unitswithan‘s’sufx(i.e.545s).Ifyoudonothavean‘s’unit,
disregard instructions on installing a transducer.
To install and use your unit:
1 Select a location.
2. Mount the unit.
3. Install the transducer.
4. Install the wiring harness.
5. Test the installation.
Step 1: Select a Location
Consider the following when you select an installation location:
• Provides optimal viewing as you operate your boat.
• Allows easy access to the unit’s keypad.
• Is strong enough to support the weight of the unit and protect
it from excessive vibration or shock.
• Allows room for the routing and connection of the
power/data
and transducer cables. There should be at least a 3-inch (8 cm)
clearance behind the case.
DO NOT mount the unit in an area that is exposed to extreme
temperature conditions.
NOTE: The temperature range for the unit is 5°F to 131°F
(-15°C to 55°C). Extended exposure to temperatures exceeding
this range (in storage or operating conditions) may cause failure
of the LCD screen. This type of failure and related consequences
are NOT covered by the manufacturer’s limited warranty.