Filter
Top Products
Reference Waypoints (cont.)
1. From the waypoint definition page, highlight ‘NEW?’, and
press
E
.
2. Enter a waypoint name, and press
E
.
3. Highlight the ‘REF’ field, and press
E
.
4. Enter a reference waypoint name (or leave the field
blank to use your present position), and press
E
.
5. Enter the bearing and distance of your new waypoint
from the reference waypoint.
6. Press
E
to confirm the ‘DONE?’ prompt.
Waypoint Symbols
The GPS 48 allows you to select one of 16 symbols
for each waypoint for easy recognition on the map dis-
play. From the symbol page, you may also select how the
waypoint appears on the map.
To select a waypoint symbol:
1. Highlight the symbol field, and press
E
.
2. Use the arrow keypad to select the desired symbol, and
press
E
.
3. The cursor will move to the display field, where you can
select which waypoint information is displayed on the
map.
4. Press
E
, and select one of the following display
options: ‘NAME WITH SYMBOL’, ‘SYMBOL ONLY,’ or
‘COMMENT WITH SYMBOL’.
5. Press
E
to confirm your selection, and
E
again
to confirm the ‘DONE?’ prompt.
Waypoint Comments
Each waypoint stored in the GPS 48 has a user-
defined 16-character comment field. The default com-
ment is the UTC (or Greenwich mean time) date and
time of the waypoint’s creation.
To change or add a comment:
1. Highlight the comment field.
2. Press
E
.
Note: You can clear the comment field by pressing
the left side of the rocker keypad.
3. Enter the desired comment.
4. Press
E
.
Waypoint
Symbols &
Comments
REFERENCE
36
Waypoint symbols enable
you to instantly get more
information about a way-
point than just its name.
The waypoint comment
field will automatically
assign the date and time of
creation to the waypoint
comment field. You may
enter a 16-character user
comment at any time.
GPS48revB.qxd 1/7/00 3:12 PM Page 36