Filter
Top Products
StreetPilot 2720 Owner’s Manual 19
APPENDIX
Installing the StreetPilot in Your Vehicle
You can use the permanent or temporary adhesive disks or the
non-skid friction mount to mount the StreetPilot in your vehicle.
Installing the Adhesive Disks
1. Clean and dry the area of the dashboard where you will install
the base.
2. Remove one side of the backing from the adhesive and place
the adhesive on the bottom of the mounting base.
3. Orient the mounting base so the locking lever is facing
you and then position the base on the cleaned area. Apply
pressure to adhere the base to the dashboard.
NOTE: The permanent adhesive disk is extremely difficult
to remove. Only install if you are sure you want to leave the
mount in that location.
Attaching the StreetPilot to the Base
1. Slide the locking lever on the mounting base to the left
(unlocked position).
2. Slide the bottom of the StreetPilot into the mounting base until
it clicks into place.
3. Slide the locking lever to the right.
Locking lever Release tab