Filter
Top Products
GPSMAP 60Cx Owner’s Manual 9
GETTING STARTED >
Transferring Data to a MicroSD Card
The GPSMAP 60Cx is equipped with a pre-installed
MicroSD card.
To install or remove the MicroSD card:
1. Remove the Battery Compartment Cover
from the back of the unit and remove the two
batteries.
2. Locate the card tray at the center of the
battery tray and check to be certain the card is
installed in the tray.
3. If you desire to remove the card, slide the tray
cover up, then lift it toward you to remove the
card from the tray.
4. To re-insert the card, lay the card in the tray,
close the tray, and replace the batteries and
cover when finished.
To transfer map data to the MicroSD card:
1. Lift the weather cover from the USB port on
the upper back of the unit. It recommended
that you use the USB port rather than the
Serial Connection port for faster data transfer.
2. Connect the USB cable provided with the unit
to the USB port on your PC and to the mini-
USB port on the back of the unit.
3. Follow instructions for selecting and
downloading maps provided with the
MapSource map data disk.
LOCK
SanDisk
USB Port
under weather
cover
Back of GPSMAP 60Cx
with Battery Cover
removed
Detail of MicroSD card tray in
Battery Compartment
MicroSD card tray
is located beneath
the batteries in the
battery compartment.
Slide the tray cover back to
OPEN, then lift to remove
or insert the MicroSD card.
Close and slide forward to
LOCK.
Unlock
Lock