Filter
Top Products
73
Appendix A
Loran TD Setup
To setup Loran TD from the Main Menu:
1. Using the ARROW KEYPAD, highlight the “Units” tab and then the “Position Format” fi eld press
ENTER/MARK.
2. Highlight ‘Loran TD’, press ENTER/MARK, then highlight ‘Setup’ and press ENTER/MARK.
3. To change the settings of any of the fi ve fi elds, highlight the fi eld, press ENTER/MARK, select/enter
the desired setting and press ENTER/MARK.
4. When done, press the QUIT key to return to the Main Menu.
To setup Loran TD from the Status Page:
1. Press MENU, then use the ARROW KEYPAD, highlight the ‘Loran TD On’ and press
ENTER/MARK.
2. To change the settings of any of the fi ve fi elds, highlight the fi eld, press ENTER/MARK, select/enter
the desired setting and press ENTER/MARK.
3. When done, press the QUIT key to return to the Status Page.
If the active GRI Chain, secondary stations or offsets have been changed since the waypoint was
created, the waypoint will now reference the active GRI-chain and secondary stations and adjust the
TD coordinates accordingly. Remember that the GPS is not relying on the LORAN signal for navigation
and actually converts the TD coordinate to a useful LAT/LON coordinate (in the background) before
storing the waypoint to memory or using it for navigation. Because of this, the unit can navigate to
a TD coordinate anywhere in the world.
Loran TD Setup Page
Selecting the Loran Chain Number.