Filter
Top Products
eTrex Venture Cx and Legend Cx Owner’s Manual 41
MAIN PAGES > MAP PAGE
Changing the Zoom Range
You can change the zoom range on the Map Page to
view a smaller area in greater detail or view a larger
area with less detail. Press the In key to decrease the
zoom range and show an area with greater detail;
press the Out key to increase the zoom range and
show a larger area with less detail.
Zoom in Zoom out
The current zoom range setting is shown in the
lower-left corner of the Map Page. If no further
map information is available, “overzoom” appears
under the zoom range When using MapSource maps,
“mapsource” appears below the scale.
Map ranges
Map Orientation
There are two map orientation options: North Up
orients the map like a paper map. Track Up orients the
map in the direction of travel. When using Track Up,
the North arrow indicates the orientation. Set the map
orientation using the Setup Map option.
Map Page Options
Use the Map Page Options Menu to
customize the Map Page. With the
Map Page open, press Menu. To
select an option, and press Enter.
The following options are available:
• Stop (Resume) Navigation
—stops navigation
and is disabled when there is no active
navigation.
• Recalculate
—recalculates a route and is
disabled when there is no active navigation.
• Data Fields
—opens the Show sub-menu so
you can select the number of data fields to show
at the top of the Map Page: Map Only, 2, 3, or 4
data fields.