Filter
Top Products
190-00516-00 GPS 10 Technical Specifications Rev. B
Page 26
File Menu
The File Menu allows you to open, save, and print sensor configurations. The items in the File Menu work
like most Windows-based programs.
Comm Menu
The Comm (Communication) Menu allows you to set the port number, baud rate, and then connect and
disconnect from the sensor.
Setup: Opens the Comm Setup Window, shown to the left. Select
the Serial Port to which the sensor is connected from the drop-
down list. Then select Auto (the program determines the baud rate
on its own) or Manual (you then enter the baud rate) for the Baud
Rate entry.
Connect: Select Connect to connect to the sensor to change or
view the configuration.
Disconnect: Select Disconnect to disconnect from the sensor.
Config Menu
The Config (Configuration) Menu allows you
configure the sensor as it is connected.
Sensor Configuration (F6): Opens the Sensor
Configuration Window, shown to the right. Many
of the fields in this window should be left alone.
Please refer to the beginning of this manual for
clarification about some of these fields. For the
most part, this window is used to enter a new
Latitude, Longitude, and Altitude for the sensor.
This is especially helpful when you are
programming the sensor for use in a particular
geographic location.
Resetting the Unit (Reset Unit) performs a reset
on the unit, much like cycling the power.
Resetting the non-volatile memory (Reset
NonVol) will clear all of the data from the non-
volatile memory.
NMEA Sentence Selections (F7): Displays the
NMEA Sentence Selections Window. If the
sentence is enabled, a check mark appears in the
box to the left of the sentence name. Click the box
to enable or disable to the sentence.