Filter
Top Products
190-00516-00 GPS 10 Technical Specifications Rev. B
Page 24
4.
Select the Serial Port to which the GPS 10 is connected. Select
Auto to have the program automatically determine the Baud
Rate, or select Manual to manually select the Baud Rate of the
GPS 10. Click OK when done.
5. Click the Connect icon , or select Comm > Connect to
connect to the GPS 10.
6. To view the current
programming of the GPS 10,
select Config > Get
Configuration from GPS (or
press the F8 key). The current
programming of the GPS 10 is
displayed in the window, as
shown on the previous page.
7. Open the Sensor Configuration
Window by pressing the F6 key
or selecting Config > Sensor
Configuration.
8. Place a check mark in the box
next to “Binary Output Data” to
change the GPS 10 to Garmin
Mode. The unit will keep this
change in the programming until
you change it again in the
software.
Note: Selecting Config > Switch
to Garmin Mode (or pressing
the F11 key) only changes the
unit to work in Garmin Mode
until power is cycled through the
unit again. For a more permanent change,
refer to step 8 above.
9. Click OK when completed enabling
“Binary Output Data.”
10. When you are ready to upload the changes
into the GPS 10, select Config > Send
Configuration to GPS (or press the F9
key). The new configuration is then
loaded into the GPS 10.
11. You may disconnect and close the
software when finished. The software
configuration can also be saved for future
reference.
Refer to Appendix D: Sensor Configuration
Software for complete information about
downloading the Sensor Configuration
Software application.