Filter
Top Products
15
JUMPER WIRE, DIP SWITCH SETTINGS
ON GDC BOARD
The GDC Board has jumper blocks and DIP switches which
tailor the specifications of the equipment. Table 4 shows the
specifications available by the jumper blocks and DIP switches.
The data to be output by the #1 and #2 pins of the DATA OUT
connector can be selected by the jumper block JP6 on the GDC
Board. The default setting outputs external navigator position
data. Input and output data formats cannot be selected inde-
pendently.
The external event switch can be selected by J5 on the GDC
board. The default setting outputs data from DATA IN/ OUT
connector.
Table 1 Specifications of jumpers and DIP SW on GDC board
repmuJ
PID/kcolB
WS
gnitteSnoitacificepS
5J
oD.rotcennocTUO/NIATADfoatademasstuptuO
vE.hctiwstnevelanretxemorflangiserusolctcatnocstupnI
6J
NItuptuorotcennocTUOfosnip2#dna1#:0033-PG
.reviecerSPGlanretnimorfatadnoitisop
tuptuorotcennocTUOfosnip2#dna1#:0033-DG
.tamrofFICniatadtneve
TUOrotagivanlanretxetuptuorotcennocTUOfosnip2#dna1#
.atadnoitisop
PID
1WS
1# foegnahcretfanonruT).ffoyllamronhctiwS(.seiromemllasraelC
.skcoldraobyeknehwro,margorp
4#noitacificeps0033-PG:FFO
noitacificeps0033-DG:NO
3#.yalpsidtolipoedivnotrahcsyalpsiD:FFO
.yalpsidtolipoedivnotrahcfoyalpsidselbasiD:NO
2#gnittesyrotcaF:FFO
To set the jumper block JP6;