Filter
Top Products
1-3
Assembling the antenna unit
The antenna unit should be assembled before mounting it. Follow the procedure below to
assemble the antenna unit.
1. Screw the guide pins (2 pcs.) in the radiator.
2. Remove the protective cap from the choke guide and radiator.
3. Grease the O-ring and set it to the groove on the choke guide.
4. Place the radiator on the radiator bracket. (Radiator direction is shown by the logo on the
bracket. If reversely oriented the radiator cannot be set to the bracket.)
5. Loosely fix the radiator to the radiator bracket with hex bolts (M10×25), spring washers and flat
washers.
6. Remove the guide pins and tighten the hex bolts.
Assembling the antenna unit
Radiator front
Guide pin (2 pcs.)
Arrow mark for the radiator front.
Antenna radiator
Do not remove teflon tube
from the center conductor.
O-ring
Choke guide
Radiator bracket
Protective cap
Spring washer,
flat washer,
10 pcs. each,
M10x25
CAUTION
Be sure to remove the guide pins
after fixing the radiator.
Injury may result if the guide pins loosen
and fall from antenna radar platform.