Filter
Top Products
8. MAINTENANCE, TROUBLESHOOTING
8-4
8.7 Simple Troubleshooting
This section provides simple troubleshooting procedures which the user can
follow to restore normal operation. If you cannot restore normal operation do not
attempt to check inside the unit. Any trouble should be referred to a qualified
technician.
8.7.1 General
General troubleshooting
If… Then…
you cannot turn on the
power
• check for blown fuse.
• check that the power connector is firmly fastened.
• check for corrosion on the power cable connector.
• check for damaged power cable.
• check battery for proper voltage output (10.8 to 31.2 V).
there is no response
when a key is pressed
• turn off and on the power. If there still is no response the key may
be faulty. Request service.
8.7.2 Radar
GD-1920C-BB requires a network radar.
Radar troubleshooting
If… But… Then…
you pressed the POWER/TX
key and the C: RADAR TX
soft key to show the radar
picture
nothing appears on the
display
• check that the antenna cable is
firmly fastened.
• check if radar source is correct.
marks, legends appear no echo appears • check that the antenna cable
is firmly fastened.
the picture is not updated or
it freezes
— • check antenna cable.
• for freeze up, turn the
processor unit on and off
again.
tuning is adjusted sensitivity is poor • magnetron may need to be
replaced. Contact your dealer.
the range is changed radar picture does not
change
• try to hit the [+] and [-] keys
again.
• turn the processor unit on and
off again.
there is poor discrimination in
range
— • adjust A/C SEA.
the true motion presentation
is not working properly
— • reselect true motion mode.
• check if heading and speed are
input.
the range rings are not
displayed
— • hit the B: RADAR DISPLY and
C: RINGS soft keys to display
them.