Fortress Technologies FS-30 Automobile Alarm User Manual


 
6
OPERATION INSTRUCTIONS
ARMING
To arm the alarm and lock the doors, press the Lock button on the transmitter. You will hear a single siren
chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be disabled if
these optional features are installed. The red LED in the vehicle will start flashing after 5 seconds. After a
short delay to allow vehicle and electronics to stabilize the system will be completely armed.
DISARMING
Press the Unlock button on the transmitter to disarm the alarm. You will hear 2 siren chirps and the lights will
flash twice. The LED stops flashing. Door will unlock and dome light will turn on if the options are installed.
SELECTIVE SILENT ARM/DISARM THROUGH REMOTE CONTROL
This system can be armed and disarmed without siren chirps on an “as needed basis. Press and release
Button #4 for arm/disarm without siren chirps.
PROGRAMMABLE SILENT ARM / DISARM MODE (CHIRP DEFEAT)
The system can be silently armed and disarmed as normal with Lock/Unlock Buttons, but no siren chirp. See
alarm programming option (#8) to enable or disable this feature.
PASSIVE ARMING / PASSIVE LOCK MODES / PASSIVE CHIRP COUNTDOWN
If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last
door has been closed. The LED will begin flashing rapidly while counting down. If a door or hood is
reopened, the system will wait (LED off) for the door or zone to close before arming. The unit will flash the
lights once. Doors will lock if passive locking is selected. May qualify for insurance discounts-check with your
agent or proprietor. When the Unit is programmed for Passive Chirp Countdown, the siren will chirp during
passive countdown, as an audible warning that arming will occur. This siren will emit a chirp every 2 seconds
as soon as the last door is closed until the system arms 30 seconds later.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold the Button #1 (Panic) for at least 2 seconds until
the siren sounds. Press Button #2 (Unlock) to reset panic mode.