Filter
Top Products
10
CARJACK PROTECTION
ACTIVE CARJACK
This feature provides Active Carjack protection and must be enabled before use through Alarm programming option
(14) See page 10. When the Ignition is on (vehicle is running), press and hold button #3 (AUX) for 3 seconds. Parking
lights will flash TWICE to confirm the Carjack countdown sequence. LED begins to flash slowly. 90 Seconds later, the
unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a full system activation with
siren/flashing light pulses for up to 5 min. To reset Active Carjack, IGNITION MUST BE ON, then press Button #2.
Siren/Horn chirp, LED goes OFF, carjack is reset.
PASSIVE CARJACK
This feature provides Passive Carjack protection and must be enabled before use through Alarm programming options
(13) & (14). See page 10. We recommend this mode should only be used in serious situations. When the Ignition is
on (vehicle is running), and a door is opened and closed, the Carjack countdown sequence will be initiated (lights flash
twice & LED begins to flash). 90 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-
warning chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. To reset Passive
Carjack, Ignition must be ON, doors must be closed, then press the override/program button (3) times. Siren chirps
once, LED goes out, carjack is reset. NOTE: Active carjack can still be used when the Passive Type carjack is
activated.
FULL-TIME CARJACK
ONLY USE THIS MODE WHEN THERE IS AN EXTREME TREAT OF A CARJACK WITH YOUR VEHICLE.
Full-time Carjack protection must be enabled before use through Alarm programming options (13) & (14). See
page 10. EVERY TIME the Ignition is turned ON or a door is opened and closed with the Ignition ON, a
Carjack countdown sequence will be initiated. 90 Seconds later, the unit will begin a Carjack Cycle consisting
of 20 seconds of pre-warning chirps turning into a full system activation with siren/flashing light pulses for up
to 5 min. You must reset the unit every time the IGNITION is turned on or a door is opened and closed when
the ignition is on. To reset Ignition must be ON, doors must be closed, then press override/program button (3)
times.
NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, Door
is opened, before entering VALET mode, and before Programming options or transmitters! It is always
in effect each time the Ignition is turned on and/or a door is opened with Ignition on! If power
becomes disconnected, then re-connected the Carjack Full-time carjack trigger will be active. Press
the override button 3 times with the Key on the doors closed to reset.