Filter
Top Products
IMPORTANT! Use only a Power Wheels
®
12 volt battery
with built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery
for at least 18 hours using the enclosed Power Wheels
®
12 volt charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than 30
hours. Failure to follow these instructions may damage your
battery and will void your warranty.
• Press the tab under the back of the seat and lift to remove
the seat.
• Squeeze the battery clamp arms together to release the
arms from the slots in the vehicle body.
• Press the battery clamp arms in and over the lock
tabs and lift the battery clamp.
•Lower the battery clamp over
the battery.
•Fit the battery clamp arms down into the slots in the
vehicle body.
• Press the battery clamp arms out over the lock tabs to
snap and secure the battery clamp arms in the slots.
• Re-assemble the vehicle seat.
• Place the battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push
firmly to join.
Vehicle
Body
Seat
Tab
Battery Installation
Battery Clamp
Arms
Slot
Slot
Battery
Motor
Harness
Connector
Arm
Arm
Slot
Slot
H
17
1
4
3
2