Filter
Top Products
M9780pr-0920
Power Indicator
Charger
Connector
A
B
9
BATTERY CHARGING
F
M9780pr-0920
E
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
ASSEMBLY
1
• Slide a
7
/16" washer onto a front axle.
• Fit a bushing (flat side first) onto the front axle.
• Repeat this procedure to assemble the other
7
/16" washer and
bushing to the other front axle.
7
/16" Washer
Front Axle
Bushing
RIGHT SIDE VIEW
• Plug the charger connector into the battery
A
.
• Plug the charger into a standard wall outlet
B
.
Notes:
- If power flow to the wall outlet is controlled by a switch,
make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
- The power indicator on the charger does not indicate the
charge status of your battery. The power indicator allows you
to see that there is power from the wall outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of
your vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to be
installed in your vehicle. Please see the Battery Installation
section on page 23 for detailed instructions on installing your
battery. If your battery is already installed in your vehicle,
simply re-connect the motor harness connector to the battery.
Close the hood.
Battery
Note: Protective caps have been added to the
threaded metal parts to prevent damage during
shipping. Please remove and throw the
caps away.