Filter
Top Products
M9780pr-0920
PROBLEMS AND SOLUTIONS GUIDE
31
M9780pr-0920
Q
Vehicle was running but Loose wires or loose connectors Check all wires and connectors. Make sure the
suddenly stopped motor harness connector is tightly plugged into the battery,
and that there are no loose wires around the motors.
Tripped thermal fuse The built-in thermal fuse may "trip" and shut down
operation of the vehicle if the vehicle is overloaded or the
driving conditions too severe. Once a fuse has "tripped",
remove your foot from the pedal and wait approximately
25 seconds before operating the vehicle again. To avoid
repeated automatic shutdowns, do not overload the vehicle
by exceeding the 130 lbs maximum weight capacity or by
towing anything behind the vehicle. Do not drive up hills or
run into fixed objects, which can cause the wheels to stop
spinning while power is still being supplied to the motors.
If a thermal fuse continually trips, contact your local
Power Wheels
®
authorized service center.
Short run time (Less than Undercharged battery Charge the battery. A new battery should have been
1 - 3 hours per charge) charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for
at least 14 hours after each use. Never charge the
battery longer than 30 hours.
Check all wires and connectors. Make sure the motor
harness connector is tightly plugged into the battery, and
that the charger is plugged into the wall.
Make sure power flow to the wall outlet is “ON”.
Overcharged battery Do not charge the battery longer than 30 hours. If you
suspect that your battery is damaged as a result of
overcharging, contact your local Power Wheels
®
authorized
service center. They can test the battery for you.
Battery is old and will not Even with proper care, a rechargeable battery does not
accept full charge last forever. Average battery life is 1 to 3 years depending
on vehicle use and use conditions. Replace only with a
Power Wheels
®
12 Volt Lead-Acid Rechargeable Battery.
Do not substitute parts.
Tripped thermal fuse The built-in thermal fuse may "trip" and shut down
operation of the vehicle if the vehicle is overloaded or the
driving conditions too severe. Once a fuse has "tripped",
remove your foot from the pedal and wait approximately
25 seconds before operating the vehicle again. To avoid
repeated automatic shutdowns, do not overload the vehicle
by exceeding the 130 lbs maximum weight capacity or by
towing anything behind the vehicle. Do not drive up hills or
run into fixed objects, which can cause the wheels to stop
spinning while power is still being supplied to the motors.
If a thermal fuse continually trips, contact your local
Power Wheels
®
authorized service center.
PROBLEM POSSIBLE CAUSE SOLUTION