Filter
Top Products
H7332pr-0920
IMPORTANT! Use only a Power Wheels
®
12 volt lead-acid
rechargeable battery. Use of any other battery will damage your
vehicle. Make sure that you charge the battery for at least 18 hours
using the enclosed Power Wheels
®
12 volt charger before operating
your vehicle for the first time. Charge the battery for at least 14
hours after each use of the vehicle. Never charge the battery longer
than 30 hours. Failure to follow these instructions may damage your
battery and will void your warranty.
• Squeeze the battery clamp arms together to release them from the
slots in the vehicle.
• Press the battery clamp arms in and over the lock tabs and lift the
battery clamp.
• Lower the battery clamp over the battery.
• Fit the battery clamp arms down into the slots in the vehicle body.
• Press the battery clamp arms out over the lock tabs to snap and
secure the battery clamp arms in the slots.
• Re-assemble the vehicle seat.
• Place the 12V battery upright in the battery compartment.
• Plug the motor harness connector into the battery. Push firmly
to join.
16
BATTERY INSTALLATION
H
3
4
H7332pr-0920
Seat
Tab
1
• Press the tab under the back of the seat and lift to remove the seat.
Battery Clamp
Arms
Slot
Slot
2
12V Battery
Motor
Harness
Connector
Arm
Arm
Slot
Slot