Filter
Top Products
14
ASSEMBLY
F
H7332pr-0920
• Insert six #6 x 1" screws through the back handlebar assembly,
as shown. Tighten the screws.
18
R
• Apply labels as shown. For best results, make sure your hands and
the areas to which the labels will be applied are clean and dry.
19
• Bend the plastic tip at the end of the microphone cord so that it forms
a "T".
• Insert the "T" end of the microphone cord into the hole in the
handlebar. Pull gently on the microphone cord to make sure it is
secure in the handlebar.
• Hang the microphone on the handlebar.
• Fit a hand grip onto each end of the handlebar. If it is difficult to slide
the hand grips onto the handlebar, moisten the hand grips with warm
water first.
Handlebar
Hole
Hand Grip
Microphone
"T" End
20
DASH AND REAR VIEW
12
10
5