Filter
Top Products
H4433pr-0920
Spacers
A
13
ASSEMBLY
F
H4433pr-0920
21
Brush Guard
20
• Position the windshield so that the molded detail on the wipers
faces the front end of the vehicle.
• Insert and
“snap” the two large tabs on the windshield into the
large slots in the dash.
• Pull up on the windshield to be sure it is secure.
Windshield
Wipers
Large
Tab
Large
Tab
Large
Slot
19
22
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through the slot
near the outer edge of the seat. Make sure the side of the seat belt
with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until the
last T-loop at the opposite end of the belt catches against the slot.
You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
T-Loops
Slot
T-Loop (Pull through slot)
Large
Slot
• Fit and hold the brush guard against the front end of the vehicle.
Hint: Using the end of a Phillips screwdriver, poke a hole in the thin,
plastic covering over the lower holes in the brush guard.
• Insert two #10 x 1" screws through the
lower holes in the brush
guard and into the vehicle. Tighten the screws.
• Fit two spacers
between the upper holes of the brush guard and the
front end of the vehicle
A
.
• Insert two #8 x 4" screws through the upper holes in the brush guard,
through the spacers and into the front end of the vehicle
B
.
Tighten the screws.
B
#8 x 4"
Screws
Side View