Filter
Top Products
WARNING
8
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
• Plug the charger connector into the battery .
• Plug the charger into a standard wall outlet .
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready
to be installed in your vehicle. Please see the Battery
Installation section on page 17 for detailed instructions
on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor
harness connector to the battery and replace the battery
cover (clamp).
Battery
Charger
Connector
• Fit the cowling cover to the cowling.
1
Cowling Cover
Cowling
#8 x
3
/
4
" Screws
• Insert four #8 x
3
/
4
" screws into the pegs in the cowling
cover, as shown. Tighten the screws.
2
Note: The illustrations in the Assembly section show the
model C0530 frame. Assembly is the same for all models
(H2836, C0530 and C0532).
Battery Charging
Assembly
F