Filter
Top Products
15
Assembly
• Once you have selected the appropriate seat position
and inserted the seat tabs into the slots in the vehicle
body, align the holes in the back of the seat with the
holes in the vehicle body.
•Insert three #8 x
3
/
4
" screws through the holes in the
seat and into the vehicle body. Tighten the screws
using a Phillips screwdriver. Do not over-tighten.
Vehicle
Body
Seat
• Fit the gas cap into the hole in the side of the
vehicle body.
Gas Cap
Vehicle Body
Note: The seat can be assembled in either of two
positions for your child's comfort.
•Position the seat upright.
• Fit the three tabs on the front of the seat into either the
1st or 2nd set of square openings in the vehicle body.
Seat your child in the vehicle and check your child's foot
to pedal distance to select the proper seat position for
your child. Reposition the seat, if necessary.
2nd
Position
1st Position
Seat
•Insert the fastener end of a long seat belt strap through a
slot in the center of the seat. Make sure that the fastener
faces the outer edge of the seat.
• Pull the long seat belt strap completely through the slot
until the T-loop at the opposite end of the belt catches
against the slot. (You will pull one T-loop through the slot.)
• Repeat this procedure to assemble the other long seat
belt strap to the seat.
Long Seat
Belt Strap
Fastener
Slots
End T-Loop
24
25
26
27