Filter
Top Products
11
Assembly
• Bend the plastic tip of the microphone cord so that it
forms a "T".
• Fit the plastic tip at the end of the microphone cord
through the small oval hole in the dash. Pull up gently on
the microphone cord to make sure the plastic tip is
secure under the dash.
• Fit the microphone to the dash.
• Fit the key assembly into the hole below the knob plate
and press firmly to “snap” it into the dash.
Microphone Cord
Plastic Tip
Key Assembly
TONE
• Before applying labels to the dash, wipe the dash with a
clean, dry cloth to make sure it is free of dirt and oils.
Make sure your hands are clean and dry.
• Apply labels as shown. For best results, avoid
repositioning a label once it has been applied.
27
28
20
9
10
31
13
Large Tab
•Position the knob plate with the large tab down.
• Fit the large tab on the knob plate into the bottom of the
square opening on the dash, as shown.
• Press near the top of the knob plate to “snap” it into
the dash.
• Fit the knobs into the holes in the knob plate and press
firmly to “snap” them into the dash.
Knobs
Knob Plate
• Press firmly above each of the front tabs to snap them
into the slots in the vehicle body.
IMPORTANT! Check each front, side and rear tab to
make sure the tabs are properly secured in the slots in
the vehicle body.
PRESS DOWN HERE
To Snap Front Tabs
Dash View
Dash View
8
9
10
11