Filter
Top Products
• Open the phone’s battery compartment door and remove
the packet of #3 x
3
/
8
" screws.
• Insert three “AAA” (LR03) alkaline batteries as
indicated in the battery compartment.
• Close the battery compartment door.
• Insert the #3 x
3
/
8
" screws into the holes in the battery
compartment door and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
+
–
“AAA” (LR03) x 3
Phone
Battery
Compartment
Door
#3 x
3
/
8
" Screw – 2
3
• Position the dash on the vehicle body. Make sure the
holes in the dash tabs align with the holes in the vehicle
body and that the channel cover is captured by the dash.
• Insert two #10 x 1" screws through the holes towards the
rear of the dash (closest to the hood area) and into the
vehicle body .
• Insert two #10 x
1
/
2
" screws through the holes towards the
front of the dash (closest to the passenger compartment)
and into the vehicle body .
• Tighten each screw with a Phillips screwdriver. Do not
over-tighten.
2
1
Assembly
Do not omit any steps. Please set aside at least 60 minutes for assembly.
F
1
2
10
• Snap the knobs into the knob plate.
Note: Gently squeeze the tabs on the knobs together
before inserting the knobs into the knob plate.
• Apply labels 17 and 18 to the key chain.
• Insert the key chain end through the key and then into
the opening in the key chain.
2
1
1
2
1
2
Dash
Channel
Cover
Tab
Key Assembly
Knobs
Key
Key Chain
Please Note:
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from this product.
Battery leakage and corrosion can damage this product.
Dispose of exhausted batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type, as
recommended above, are to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from this
product before they are charged.
• Battery chargers used with toys must be examined
regularly for damage to the cord, plug, enclosure and
other parts. In the event that such damage is found, the
toy must not be used with the battery charger until the
damage has been repaired.
18
17