Filter
Top Products
Assembly
15
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the belt
catches against the slot. You will pull one T-loop through
the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
End
T-Loops
Slot
T-Loop (Pull through slot)
13
• With the flat sides of the windshield brackets facing the
dash, fit the screw pegs on the windshield brackets into
the holes in the top surface of the dash.
• Insert two #8 x 1" screws into each windshield bracket.
• Tighten the screws with a Phillips screwdriver.
• Do not over-tighten.
Windshield
Brackets
#8 x 1" Screws
#8 x 1" Screws
Hood
Tabs
• Position the hood over the front of the vehicle body
as shown.
• Insert the tabs on the hood into the slots in the
vehicle body.
• Close the hood.
Slot
Slot
12
13
Slots
• Fit the slots on the back side of the windshield onto the
windshield brackets.
• Insert a #10 x 3" screw through the hole in one side of the
windshield and through the holes in the hinge bracket.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Insert a #10 x 3" screw through the hole on the other side
of the windshield.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
Slots
#10 x 3" Screw
#10 x 3" Screw
Bracket
Windshield
14