Filter
Top Products
16
Assembly
Rear View
Rear View
Rear View
Rear Axle Cover -
Long Half
Rear Axle Cover -
Short Half
• Position the short half of the rear axle cover behind the
rear axle and snap it onto the rear axle.
• Position the long half of the rear axle cover in front of the
rear axle and snap it into place.
• Insert four #6 x
1
/2" screws (black) into the rear axle cover
and tighten with a Phillips screwdriver. Do not over-tighten.
24
Shock Half -
Small
Shock
Half -
Large
Rear
Support
End
Cap
• Insert two #6 x
1
/2" screws (black) through the holes in
the shock set halves.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other shock set
to the other rear support.
25
• Fit the large half of one shock set against one of the
rear supports. Make sure the end of the large shock
half fits into the end cap at the bottom of the support.
• Fit the small half of the shock set against the other side
of the rear support. Make sure the screw holes in the
two shock halves are aligned.
23