Filter
Top Products
Assembly
• Fit a mirror lens to a mirror housing.
• Insert a #8 x
1
/2" screw through the back of the mirror
housing into the mirror lens. Tighten the screw with a
Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to assemble the other mirror lens
to the remaining mirror housing.
• Fit a mirror housing to a handlebar, as shown.
• Fit and hold a mirror clamp to the other side of
the handlebar.
• Insert two #8 x
3
/4" screws through the back of the mirror
housing and into the mirror clamp.
• Using a Phillips screwdriver, tighten the screws to hold
the mirror housing upright. Do not over-tighten.
• Repeat this procedure to assemble the remaining mirror
housing to the other handlebar.
Mirror Clamp
Mirror Housing
Mirror Housing
Handlebar
Mirror Lens
37
38
21
• Fit the fender tip onto the front of the fender.
• Insert two #8 x
3
/
4" screws through the fender tip and
into the vehicle frame. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
39
Vehicle
Frame
Fender Tip
Front
Fender
74370a-0920.qrk 5/21/01 2:06 PM Page 21