Filter
Top Products
Assembly
T
M
26
• Slide the right and left handlebars through the holes in
the front fork.
• Align the screw holes in each handlebar with the screw
holes in the front fork.
• Insert a #8 x
3
/4" screw through each front fork and into
each lower hole in each handlebar . Tighten the
screws with a Phillips screwdriver. Do not over-tighten.
• Insert a #8 x
3
/4" screw through each front fork and into
each upper hole in each handlebar . Tighten the
screws with a Phillips screwdriver. Do not over-tighten.
2
1
Front
Fork
Left
Handlebar
Right
Handlebar
17
• Fit a handgrip on the end of each handlebar.
• Note the R (right) and L (left) markings on the handlebars.
Note: If it is difficult to slide the handgrips onto the
handlebars, moisten the inside of the handgrips
with water.
25
Handgrip
Handgrip
Handlebars
“R” “L”
T
M
• Slide the fork axle up into the bottom of the front fork,
through the neck and steering stop, and out the top of
the front fork.
• Fit a .354 (small diameter) cap nut on the end of the
fork axle.
• Support the fork axle and tap the cap nut with a hammer
to secure it on the end of the axle.
• Pull on the .354 cap nut to make sure it is secure on the
fork axle.
Fork Axle
Front
Fork
.354 (Small
Diameter)
Cap Nut
24
2
1
74370a-0920.qrk 5/21/01 2:06 PM Page 17