Firstech, LLC. P2W900FMR Automobile Alarm User Manual


 
9
Starter Icons –
Engine Running
This icon will be displayed while the vehicle is running after it has been remote started.
Start Availability
This icon will be displayed when the vehicle is ready to be remote-started. If this icon is not displayed, you will
not be able to remote-start the vehicle.
Timer Mode
This icon will be displayed when Timer mode is active. Timer mode can be set up to start the vehicle every 1.5,
3, or once very 24 hours.
Cold/Hot Start
This icon will be displayed if Cold Start mode is currently active. Cold Start mode will start the vehicle if the
vehicle reaches a preset hot or cold temperature. These temperatures can be adjusted by the installer.
Alarm Icons –
Siren
This icon will be displayed if the siren is turned on. Turning the siren off only applies to the chirps when arming,
disarming, or remote-starting. The siren will still sound if the alarm is triggered.
Hood
This icon will be displayed if the hood is opened while the system is armed. The remote will beep rapidly while
displaying this icon. This means that the alarm was triggered. If this icon appears while trying to remote-start the
vehicle, it means that the vehicle will not start because the hood is open.
Impact
This icon will be displayed if an impact to the vehicle is detected while the system is armed. The remote will
beep rapidly while displaying this icon if the impact is hard; this means that the alarm was triggered. If it beeps
slowly while displaying this icon, that means that the impact was soft and that the alarm simply gave four
warning chirps.
Door
This icon will be displayed if the door is opened while the system is armed. The remote will beep rapidly while
displaying this icon. This means that the alarm was triggered. If this icon appears while trying to remote-start the
vehicle, it means that the vehicle will not start because the door is open.
Trunk
This icon will be displayed if the trunk is opened while the system is armed. The remote will beep rapidly while
displaying this icon. This means that the alarm was triggered. If this icon appears while trying to remote-start the
vehicle, it means that the vehicle will not start because the trunk is open.
Car Call
This icon will be displayed while someone is attempting to contact you using the RPS sensor. To trigger the
RPS sensor, you must knock on the windshield where the sensor is located. Something that creates a higher
pitch, like a key, is better suited to trigger the RPS.
Advanced Icons –
Passive Mode
This icon will be displayed if Passive mode is currently active. Passive mode will automatically arm the system
30 seconds after the last door is closed or 30 seconds after the system was disarmed if no door was opened.
This mode is ignored while the ignition is on with the key.
Drive Lock
This icon will be displayed if Drive Lock mode is currently active. Drive Lock mode will lock the doors
automatically if the ignition is on and the brake is pressed or if the ignition is on and the engine exceeds the idle
RPM multiplied by 2, depending on the options set by the installer. The doors will be unlocked when the ignition
is turned off. In a manual transmission vehicle the doors will unlock when the emergency brake is set.
Turbo Mode
This icon will be displayed if Turbo mode is currently active. While Turbo mode is active, the vehicle will remain
running for a preset time after the emergency brake has been set and the key has been removed from the
ignition.